Ten minutes twice a year prevents most garage door breakdowns. Run through this garage door maintenance checklist every spring before the heat arrives and again in the fall.
Look and listen
- Watch the door open and close. It should move smoothly without jerking.
- Listen for grinding, scraping or popping.
- Check that both sides rise evenly.
Inspect the hardware
- Rollers: chipped, cracked or wobbling rollers need replacing.
- Cables: look for fraying or rust near the bottom brackets. Look only; don't touch.
- Springs: look for gaps, rust or stretched coils.
- Tracks: clear debris and check for bends.
Lubricate
- Hinges, roller bearings and springs with garage door lubricant.
- Opener chain or screw, per the manual. Belts need no lubricant.
Test the safety systems
- Balance: disconnect the opener and lift the door halfway. It should stay put.
- Auto-reverse: place a board flat on the floor under the door. The door should reverse on contact.
- Photo eyes: wave an object through the beam while closing. The door should reverse.
Seal out the weather
- Replace sun-cracked bottom rubber and worn side seals before monsoon season.
- Brush or blow dust and grit out of the tracks after storms.
What not to DIY
Leave springs, cables and bottom brackets alone. If the checklist turns up a problem, book a garage door tune up or garage door repair. Frayed cable? See garage door cable repair.
Call (866) 629-2916